a update process of the toyan base build so far I've got the mounts done but haven't installed the engine just waiting for a replacement one way bearing for it at this stage I've got part of the control circuit wired up there's 3 switches plus push button one is the main power and the others are connected to a 12v relay 3 relays in total the whole idea why the 3 relays is to keep the voltage to the gow igniters the fan and electric Start on 2s 7.4v and the main controller for the pannels and relays at 14.8v this achieved by using 2 2s lipos connected in series and a wire fron the centre point to split the battery's if you see my wiring schematic it may confuse you to it being positive and negative on that same point in the center I did it this way to split loads on both battery's