Maiden and 2nd flights of my scratch-built RC Powers Eurofighter version 5, May 17, 2022. Overall I am very happy with the way this plane turned out and it flies very well, even in wind. I am looking forward to upgrading the motor from the XING 2750kv to an EMAX 2300kv motor, which is what I would normally use in this type of setup, but I didn't have one laying around at the time of finishing the aircraft. I have some on order now and will upgrade in the coming weeks and will share the flights in the near future!

Aircraft & Flight Information:
Model: RC Powers Eurofighter, version 5
Plans: https://www.rcpowers.com/rcpowers-pdf...
Center of Gravity: Middle of range set in plans (10cm from leading edge, just ahead of mark)
Flight Time findings with this setup flying slightly "reserved":
3m30s on 1300mah 8% remaining (low)
3m45s on 2200mah with 25% remaining (good) - recommend
Transmitter: Spektrum DX8 G2
Receiver: Spektrum AR8010T w/Satellite Rx
Servos: E-Flite A332 Metal Gear http://www.horizonhobby.com
Motor: Xing 2750kv (maiden flights)
EMAX RS2205 2300kv - Recommend
ESC: Hobbyking 40A ESC w/BEC https://hobbyking.com/en_us/hobbyking...
Prop: Racedayquads 5x5x3 https://www.racedayquads.com/
Batteries:
Ovonic 4S 50C 1300mah Lipo w/XT60
Spektrum 4S 50C 2200mah Smart Lipo w/IC3 - Recommend
Construction: All parts cut by hand using 6mm Depron from https://www.rcdepron.com/
Pushrods: Du-bro 0.047mm Micro2 Pushrod System
Control Horns: Du-bro Micro Razor Control Horns
Finishing: Krylon Short-Cuts Spray Paint, Minwax Poly-crylic "Clear", and Acrylic Paint
Vinyl Graphics: Amazon.com
Navigation Lights: Viloga LED Light Kit, Rechargeable - Amazon.com
Adhesives: Foam Safe Thin CA, Hot Glue, Foam-Tac Foam Adhesive, Epoxy, 3M Blenderm
Hinges: SIG CA Hinges
Motor mount: 1/8" Maple wood