My table saw has horrible dust collection, second only to my miter saw. I've been looking at buying an overarm dust collection hood but they're expensive and won't necessarily fit a small job site saw. I decided to DIY one out of plywood and acrylic. I struggled with the design for a long time but decided enough was enough and I needed to just start building. I'm happy with the outcome although I could probably make some improvements to the dust hood design. After using this version for a while I'll know exactly how to upgrade it later.

T-bolts: https://amzn.to/489l5j1
T-bolt kit: https://amzn.to/3szV1x3
2.5” flexible dust hose: https://amzn.to/44WsL59

🖥️ Website: https://www.fangerwoodworking.com/

🔨 Tool links (Amazon links are affiliate links which I may earn a commission from if items are purchased, however, they are not sponsored products):
Safety Gear
Micro jig narrow rip push block: https://amzn.to/3Nl97ZF
Micro jig paddle push block: https://amzn.to/43Ic9ON
Milescraft push stick: https://amzn.to/3NDlDoW
ISOTunes ear protection: https://amzn.to/44aYpMd
Measuring
FastCap measuring tape: https://amzn.to/3qYM9Ao
Setup blocks: https://amzn.to/3NFobCZ
Sanding
Bosch sander: https://amzn.to/3qVilEE
Saws
Bosch job site table saw: https://amzn.to/46t1nhl
Bosch track saw: https://amzn.to/43RNS8T
Joining
wen biscuit joiner: https://amzn.to/3CGt8Fm
Drilling
Forstner Bit Set: https://amzn.to/3NGbMi8
Other
auto vacuum switch: https://amzn.to/42SayEE
2P10 super glue and activator: https://amzn.to/3Pot7gU
Bosch dust extractor: https://amzn.to/3PmF8Dk
WEN air cleaner: https://amzn.to/3JoWj3B