Features

The elevator integrated drive and controller is designed with closed

loop vector controller for higher performance.

• Zero-speed torque compensation system without load weighing

device helps save cost.

Dynamic PWM carrier modulation technology ensures reduced motor noise.

The elevator integrated drive and controller is suitable for both synchronous and asynchronous motor.

• Dual 32-bit embedded microprocessor.

• All Type of encoder is supported.

This product is applicable for residential lift, goods lift, car lift, ramp elevator, Home Lift, Hospital Lift.

• This product Parallel and Serial communication both option available.

Redundancy control through Multi-CPUs. equipped with CAN Bus, Mod Bus and GSM Communication Technology.

Based on displacement calculation methods derive N velocity profile to achieve optimum direct-to-floor distance control

• Simple 4 wire serial communications to commission duplex group control Group control with less than 8 elevators is based on fuzzy logic control theory in-built real-time clock to facilitate time-sharing control and elevator management

• Flexible emergency backup power; 220Vac UPS power input makes emergency evacuation easy.

Automatic identification operation between short-floors.

• Handheld Operation Tools: Mini Keypad, PDA, PC to facilitate easy commissioning.

60 fault codes to facilitate easy diagnostics.

Power on reset run to groupand floor is not required.

Shaft position learning is standard.

Direct-to-floor landing. Smooth ride comfort, optimal travel mean time.

Power on reset run is not needed.

Practical reliable power Failure auto rescue emergency operation using

220V. 1ph UPS/ARD.

Automatic identification operation between short-floors with different floor heights.

Advance door opening and re Leveling using option card.

7 segment LED display for floor position indicator.

Wide variety of door function control lo meet different needs in freight lift doors requirement.

Parallel wiring control for all digital input and output.

Optimum Exclusive function, quick easy start-up periods.

Pre-factory default parameters setting facilitate zero parameter setting

at site.

• All inputs and outputs are user programmable.

Suitable for auto door as well as manual door.

Applications:-

Simplex. Duplex. 3-8 Group control elevator.

High Speed. Medium speed. Low speed.

Superior elevator, passenger elevator, medical elevator, residential elevator. Disabled elevator etc.

Elevator rated speed 4.0 m/sec

Floor level 1 Each CCB I Car Call Board can adopt up to max. 16 floors. Above 16 serial link additional CCB up to 64 floors and in parallel

communication up to 16 floor and with extension board Up to 32 floors.

Technical Specification

Power Rating:-

2.2 kW to 45 kW, 3 Phase 380/400/415V

2.2 kW to 30 kW. 3 Phase 220V

2.2 kW to 3.7 kW. 1 Phase 220V

#home elevator
block terminal
#transformer
#Smps #electrical
#rectifier
#motherboard
#fuse pcb
#lift
#push botton
#emergency stop switch
#chowk
#contractor
#NO NC
#ADCO DRIVE V3F