Thanks For watching the Video. If you liked what you saw please subscribe and hit that like button. Hit that bell icon to be notified when my next video is uploaded so you don't miss out. 

You can find the connectors that I used to make the console here. 
https://cults3d.com/en/3d-model/home/...

The cut directions are as follows. Start with a single sheet of 4x8 plywood. Cut down 3 long pieces of 16"x 8' lengths. Set aside one of them this will be the base. From the other two you will cut down 16" x 5' lengths. These will be your top and middle long shelves. From those off cuts you will cut one 16"x24" as your left side vertical support , Three 16"x12" as your bottom shelf support and two 16"x12" as your top shelf support. 
In total you will need 24 sets of connectors. 

Hardware can be found here. 
M5 x40mm Socket Head x 2 https://amzn.to/2VC2QxD
M5 Hex Nuthttps://amzn.to/35tulOh

Tools Used
Festool TS-75https://amzn.to/2VAZPxH

Festool Tracks used
https://amzn.to/2oBPoh9
https://amzn.to/2MEFFPd

Tough Built Saw Horse https://amzn.to/2OOA8Zb

Simple Finish https://makerbrandco.com/collections/...