0:00
I received a junk engine welder from an iron garbage shop, and the operating time is 1630 hours.
Generally, it is necessary to replace the piston ring etc. in 1000 hours, so we will disassemble and judge the quality of each part.
0:40
It contains a mysterious liquid that is not gasoline.
3:14
The board is not damaged and there is no puncture of the capacitor, so please make sure it is a good product.
It's a gambling because if the base is broken, it's useless.
4:44
A slide hammer was used to remove the rotor.
You can also use a long bolt to remove it.
5:03
Remove the stator coil, this part creates AC100v and welding current.
6:55
The puller needs to not only apply tension, but also give an impact.
7:17
This part generates DC12V.
8:45
The valve stem seal is rolling.
9:38
Basically, it is maintained at the compression top dead center.
11:38
It seems that it will take 3 weeks for the parts to arrive, so the continuation will be the second part.
Thank you for watching.

I got a welder that needs to be repaired.
However, it takes three weeks for the parts to arrive, so it cannot be completed.

It is a work of BGM DOVA-SYNDROME / shimtone.

#Details in the summary section
#Denyo
GAW180
#restoration