This video shows the repair of a pair of brackets holding the table of an old table saw on the base of the machine.

intro 00:00
cutting the blank 00:10
milling the faces 00:15
scribing positions of dowel pin holes 00:53
center drilling pin holes 01:55
drilling pin holes 02:18
reaming pin holes 03:00
locating position of thread 03:36
center drilling thread hole 04:02
drilling thread hole 04:14
drilling bolt holes 04:35
setup for milling the back side 05:54
milling the back side of the original casting 06:51
test fit 08:08
M6 threading 08:27
drilling and countersinking bolt holes 09:20
joining the casting and the new plate 09:36
milling the slot 11:10
finished pats 12:06
test fit on the table saw 12:20