Published On Mar 25, 2023
Artisan Woodworking - CNC Machining - Laser Engraving - Custom Furniture
Adding pneumatic pop up pins to my CNC. I wanted to add these when I created my new vacuum setup, just like all the big guys. My previous setup used dog holes with 3D printed pins, but the holes wallowed out and became inconsistent, plus I'm lazy and it was annoying to re-adjust these all the time. Also, since they were always in, I cut through them more times that I would like to admit!
Affiliate Links:
Pins:
TAILONZ PNEUMATIC 20mm Bore 50mm Stroke Pneumatic Small Thin Cylinder Aluminum Pneumatic Air Cylinder SDA20-50
https://amzn.to/3nodFFk
Regulator:
TAILONZ PNEUMATIC 1/4 Inch NPT Automatic Drain Air Filter Pressure Regulator
https://amzn.to/3lHPMIx
Switch:
TAILONZ PNEUMATIC 1/4"NPT 5 Way 2 Postion Air Hand Lever
https://amzn.to/3FS5DLg
Hose Splitter:
SANFU Air Hose Connector- 2 Way Air Hose Splitter,1/4 In NPT
https://amzn.to/3K8uCg3
1/4 NPT to Push Connector:
1/4 Female NPT Push to Connect Air Fittings
https://amzn.to/3LQaY9M
6MM Hose Kit:
TAILONZ PNEUMATIC Blue 6mm OD 4mm ID Polyurethane PU Air Hose Pipe Tube Kit 32 Meter 100ft
https://amzn.to/3ngeUGJ
6MM Hose Fittings Kit *ONLY NEEDED IF DOING MORE THAN 7 PINS*
TAILONZ PNEUMATIC 6mm od Push to Connect Fittings Pneumatic Fittings Kit
https://amzn.to/42F5DYS