A workbench is essential for woodworking DIY, which is essential for clamping on a table or assembling boards during bonding.
However, it has been used for more than 3 years, and I have a drawer for storage, but at that time I had no knowledge and dug a groove in the side plate and used it as a rail.

However, after three years, the board was worn and slippery, and the drawers became heavier.
Also, since the workbench has a depth of 650 mm, it is very narrow as it approaches the center of the room.
So I was worried about various things and decided to rebuild the workbench.

As a concept
① Compactness that does not overwhelm the room
② Maximum storage
③ Adjust the height of the top plate to your height

I will make it like this, but there were various problems in removing the old workbench so far, and it took a long time, but I managed to complete it.
I was also able to purchase parts cases with good cost performance, so I'm glad I remade them.

Parts stocker (Amazon link)
https://amzn.to/2LHUdR8

Since the video has become longer, I created a playlist.
0:00 Greetings
0:08 Current status of old workbench
0:38 Assembling the new workbench (frame)
08:03 Assembly of shelf holders for parts cases
12:15 Installation of slide rails
15:48 Drawer assembly
29:33 Wall panel mounting
31:59 Completion and introduction of workbench
32:18 Explanation of automatic closing of slide rail
34:51 Workbench dimensions and drawer dimensions
35:44 Impressions after the workbench is completed

#Workbench #Storage #Slide rail