🔥🔥Take a regular CD and fix the LED lamp! Many don't know about this, I am glad to welcome you. Today I wanted to share with you an amazing way to restore an LED lamp using a CD. This method allows you to fix any LED failure and extend the life of your lamp.

The first step, after you have unplugged the lamp, is to carefully disassemble it. When examining the inside of the lamp, it is impossible to immediately determine which LED has burned out, so we connect the lamp to the network and check each contact. If you short-circuit the faulty LED with a regular wire, it should light up. This way we determine the cause of the malfunction.

After we have found out which LED is faulty, we carefully remove it without damaging the contacts. Now we are ready to start repairing using the CD.

To do this, cut off a small part of the CD using scissors and apply electrical tape to the inside of the disc to remove the coating. The inside of the disk has an ultra-fine coating, which is what we need. Then we glue this part of the CD as tightly as possible to the contact where the faulty LED was previously located.

Now our lamp is fully operational, but before finishing, we need to carefully seal all the parts. To do this, we use a small piece of polystyrene foam. Expanded polystyrene and glue are ideally combined, providing strong contact fastening and protection from overheating.

And now, as I promised, your LED lamp is working again and will serve you for a long time. I hope you liked my idea. Please share in the comments what lamp repair methods you already know. Thank you for your attention and wish you all the best!