Published On Jan 8, 2023
3D Printer enclosures are too expensive, so I built one from scratch!
My Prusa MINI+ was struggling with ABS print warping on the print bed, even at 100C. The issue? I didn't have an enclosure to keep warmer air around layers towards the top of prints. Looking online I found that off-the-shelf solutions were too expensive for my budget, so I built this one from pine and 2mm acrylic sheets.
🌐 Links
PDF of the design:
https://www.dropbox.com/s/3z13xyn5inz...
STL files for the frame brackets, and magnetic clasps
https://www.dropbox.com/sh/dozu6s9ebg...
😎 Social Stuff
Twitter: / akamatchstic
Patreon: / akamatchstic
🎞️ Chapters
00:00 - Introduction
01:46 - Frame assembly
04:56 - Acrylic panels
06:22 - Door clasps
08:19 - Showcase
10:00 - Future improvements
ℹ️ Attributions
Fabweaver - Warping diagram
https://blog.fabweaver.com/industrial...
🎵 Music
TABAL - Inside Space
• TABAL – Inside Space
nihilore - Garden
http://www.nihilore.com/prog-rock
Punch Deck - Persistence
• Punch Deck - Persistence
Grease - You're The One That I Want
• Grease - You're The One That I Want (...
Alex-Productions - Startup
• Minimal Technology Corporate by Alex-...
Corbyn Kites - Instant Crush
• corbyn kites - instant crush [ synth...
Home - We're Finally Landing
• HOME – We’re Finally Landing [Synthwa...
Keywords: Prusa Mini, 3D Printer, ABS warping, DIY