Scratch built wiring loom on a budget.
Using an aftermarket wiring module, wires, voltage regulator and various odds and ends.
Total cost approximately £200.
This wiring module was purchased from Car Builder Solutions in the UK.
I am not paid by them but can happily recommend them!

Previous episodes:
Part 1+2 - Design and chassis build
Part 3 - Wooden Buck
Part 4 - Bending aluminium side panels
Part 5 - Shaping aluminium panels
Part 6 - Welding aluminium panels
Part 7 - Aluminium panels
Part 8 - Aluminium panels
Part 9 - Superleggera frame
Part 10 - Superleggera frame II
Part 11 - Rear bodyshell
Part 12 - Front wings
Part 13 - Framework
Part 14 - Interior panels

Thanks for watching!

0:00 Module
2:14 Wiring and instructions
2:55 Crimp and solder
3:36 Connect terminals
7:25 Engine bay
8:05 Rear lights
8:40 Heat shrinking
9:25 Earths
10:24 Testing
11:49 Starter motor
12:57 Radiator fan
13:32 Engine start
15:07 Finishing loom