Published On Jan 14, 2023
The hot end used on a Kingroon KP3S 3d printer has an 'interesting' design that unfortunately makes clogs very likely to happen.
In this video I'll show you why the clogs happen, how to remove a clog and also give you some tips that I have used to prevent them happening again.
KP3S Pro Slicer Profiles:
https://drive.google.com/drive/folder...
Affiliate links (If you purchase something after clicking any of the below links I may earn a small commission at no cost to you. This is a great way to support the channel)
Kingroon KP3S Pro: https://s.zbanx.com/r/RG1q9lv9NNdY
Discount Code: BF3P
Heatgun:
https://amzn.to/3IUneVc
Nozzle Spanner(wrench):
https://amzn.to/3XsFHMR
..............................................................................................................................................................
BUY ME A COFFEE
If you're enjoying my content, why not consider supporting the channel by buying me a coffee?
Even very small amounts are greatly appreciated and re-invested into bringing you better content.
https://www.buymeacoffee.com/rickyimpey
You can also use the YouTube 'Thanks' button above if you prefer.
...............................................................................................................................................................