G'day everyone,

I have started the process of upgrading my Sieg x2.7 vertical mill. Over the few moths that I have been getting to know this mill, I have made a few modifications and upgrades that have drastically improved the easy of use of the mill.

In this video I will be talking about 7 easy improvements that I have done to the mill that can be done in the matter of a few hours. These include removing the clutch on the leadscrew for easier use of the table feed. Replacing the quill locking bolt with a permanent handle. Adding t-slot inserts to prevent chips building up in the t-slots. Using coolant and cutting oil on the mill and making a non spill holder. Making a drainage system for the mill table. Making a chip guard/chip shield.

Cheers

Timestamps
0:00 - Intro
0:19 - Remove the clutch on the handwheel
1:01 - Replace the quill lock bolt
1:55 - T-Slot Inserts
3:12 - Mill Coolant/Cutting Oil
4:22 - Cutting Oil Storage
5:41 - Coolant Drainage
9:08 - Chip Guard/Shield
10:20 - Floor Mats

#machining #workship #DIY

Mill - Sieg X2.7L
Lathe - Sieg c3 7x14 Mini Lathe