Published On Oct 24, 2018
This is just so simple. All you need is mica, glastac and some Bullseye Thinfire paper. Fuse between layers of Bullseye Glass...
-Mix the mica with enough Glastac Fusing Glue to make it brushable.
-Brush onto the thinfire paper to give an even coating.
-Cut with scissors, knife or craft punch and fuse between two layers of 3mm Bullseye Glass using the following schedule:
Segment Rate Temp. Hold
1 139C/hr 538C 4 hours
2 139C/hr 800C 15 mins
3 999 482C 1 hour
4 83C/hr 371C end
FEATURED PRODUCTS:
Mica Powder (Glitter Bronze): https://warm-glass.co.uk/glitter-bron...
Glastac Glue: https://www.warm-glass.co.uk/bullseye...
Thinfire Paper: https://www.warm-glass.co.uk/thinfire...
Butterfly Punch: https://www.warm-glass.co.uk/butterfl...
Bullseye Deep Cobalt Blue Opal 3mm Glass: https://www.warm-glass.co.uk/bullseye...
Bullseye 3mm Tekta Glass: https://www.warm-glass.co.uk/bullseye...