In this video I show some insight on the steps I took to create this huge resin bar top. I list materials used along with some of my best practices I use the most.

Material List / Steps

Step 1 - Coat plywood w/ gen. table top epoxy
SAND / CLEAN
Step 2 - Mix pigments into your TT 804 Epoxy. Pour and get the bar covered!
SAND / CLEAN
Step 3 - Mix up a few buckets at a time here. This is the wave layer so you will need your base color and white. Use a strong heat gun to move your white pigment into the base layer.
SAND / CLEAN
Step 4 - Repeat Step 3 :)
SAND / CLEAN
Step 5/6 - Fill in all of your wave gaps and get your bar flat with the TT804. Leave it clear and a few coats will make this bar strong!

Subscribe for more! Comment any questions you have.