This video was made in our neighborhood thus the wind (9mph with gusts to 18mph) was quite intermittent due to the surrounding houses and trees.

In this video, I've added a mount with a 16mm ball bearing pivot that can be attached to a pole via an M8 by 1.25mm thread. I used a 50mm bolt threaded into the pivot and held vertical using my trusty vacuum vice.

Files and instructions available here:

https://www.instructables.com/Whirlig...
https://cults3d.com/en/3d-model/gadge...
https://www.myminifactory.com/object/...

Designed using Autodesk Fusion 360, sliced using Ultimaker Cura 4.12.1, and 3D printed in Tough PLA on Ultimaker S5s and an Ultimaker 3e.