Published On Jul 18, 2023
Dont touch Phase Offset after Auto Learn
Once you set up the email and it's bonded to your phone, before the autolearn sequence, go to
parameters - expert parameters.
In that first section,
PARAMETERS -
Rated voltage to your nominal battery voltage
pole pairs to 4
Max line current 30
Max phase current 80.
temp sensor 1
....
Then, scroll down to
PID PARAMETERS
Should read
An 0
Start 4
Mid 8
Max 12
Speed 9
Moe enable
...
last go to Protect near the bottom
Verify your lowvolprotect number and change it if needed..
Then click save.
....
Go to the graph menu.
Make sure the chain is off the motor.
....
click auto-learn.
Slowly twist throttle to full. It should beep and then try to spin backward.
It may beep again or say error.
Release the throttle. It should give you a green check at the bottom.
If not, redo auto learn.
If good click exit auto learn.
....
See if motor is spinning correctly if not, go to expert ble again and change
motor direction to 1
Maxspeed 8500
Rated power 6000
Rated speed 12000
Backspeed 400
Change max line current to 60
Max phase current to 250
ThrottleResponse to 0line
Throttle deccel should be like 224
Throttle acc should be 222 or close
Throttle low .95
Throttle high 4.1
....
Shoutout to @EmxBrandon for the awesome vids on wiring up the controller here's my addition with the ec4p motor!
....
All credit goes to those who helped in the process, Frank Lazar and Emx Brandon !
#razorcrew #razorworldwide #mx500 #pocketmod #sx500 #rsf650 #mx650 #mx350 #razorbikes #razorscooter #modifiedrazors #electroandco #electrobraap #ebike #minimoto #pocketrocket #amorge #fardriver #ec4p #emx #72vrazor #crazycart #crazycarts #crazycartshuffle #crazycartshift