A lot of people think of cornhole boards are just a DIY project. Well, we make custom cornhole boards all of the time and we make MONEY doing so.

In this video, I break down my steps to building clean and durable cornhole boards. Efficiency is key and if you take my advice, I promise you can make enough money from cornhole boards to make shop improvements, upgrade your tools, etc.

If you have any questions or feedback, please leave a comment!

Here is the cutlist:
3/4" Plywood: (2) 24" x 48"
2x4: (4) 47 7/8", (4) 20 3/4", (4) 12"

Other Materials needed:
- Pocket Hole Jig (a total of (16) 1-1/4" pocket hole screws are needed 2-1/2" if using Kreg Jig)
- Drill (3/8" & 3/4" drill bits)
- (4) 3/8" bolts (4" long)
- (4) 3/8" washers
- (4) 3/8" nylon lock nuts
- 6" hole saw or router jig (if using a router, 1" flush trim bit)
- Wood glue
- Brad nailer and nails
- Clamps (not necessary, but definitely help)
- Old paint can
- Socket wrench to tighten bolts
- Choice of paint/primer or stain
- Choice of clear coat (water based or oil based)

Here's a link to a lot of these materials in my Amazon store: https://www.amazon.com/shop/lazylabacres

My Website: https://www.lazylabacres.com

Instagram:   / lazylabacres  

#diy #howto #cornholeboards