This is a complete tutorial on how you not only restore your swamp cooler, but how you replace and rebuild it. I hope it helps somebody out here in the desert. Time stamps below if you want to jump forward throughout the video.

What you'll need to repair or restore your swamp cooler: 1:25
What's the purpose of a Swamp Cooler: 6:10
Taking apart your old swamp cooler: 9:10
Disconnecting the electrical circuit: 14:58
Measuring your belt for replacement: 22:07
How to get it on the roof: 24:08
What does the New swamp cooler come with: 24:27
How to remove the pulley from the motor: 27:00
How to change the motor pigtail: 33:40
what wires are needed 120v swamp cooler motor and pump: 44:56
How to feed the harness through the new cooler: 46:50
side note I used 3/4" hole saw bit for the main harness and should have used a 1/2" drill bit for the water inlet.
Double Checking your wires prior to turning on the main power supply: 48:32
Water inlet leak check:50:17
Success!! My Final Thoughts: 50:35
BE SURE TO SUBSCRIBE SO YOU CAN BE NOTIFIED WHEN I POST NEW CONTENT & HEAD OVER TO MY DAD'S CHANNEL WHERE HE SHARES HIS WISDOM IN VIDEO'S AS WELL LINK LISTED BELOW!! THANKS FOR YOUR SUPPORT!!

THE HOME HANDYMAN CHANNEL:

   / @thehomehandyman