Published On Dec 12, 2022
There was a request from someone to go through the entire print process with the Sonic Pad, so here it is!!!
This video goes through my entire process when I print, from slicer setup to removing supports.
I explain many of the basic slicer settings that I use in Cura, as well as some of the extensions that I make sure to install, including Moonraker (watch to find out what it is for!!!)
As a side note, I know that up to this point, my production value has been a bit lacking. Rest assured, I just upgraded my hardware, and the quality should see a big boost soon. (Sorry, not on this one. Half the editing was done before I got my new PC)
LINK TO THE MODEL USED FOR THIS VIDEO: THANKS TO THE CREATOR
https://www.printables.com/model/6109...