Update: For some reason I forgot to include the part number for the fuel line clips. Here is the part #: 117-078-00-41

In this detailed video, I install the M117 Bosch fuel distributor and the sealing ring for the control piston on my 1987 560SL. This is one of my best and most detailed videos to date. Please subscribe to support my YouTube channel.

I am documenting every part of the 560SL restoration build . The idea is to end up with the best documented 560SL rebuilds on the Internet.

Links to the manual and links to all tools used in this video are below.

I want everyone who visits my channel to know about a friend of mine named Tasos. His videos inspire me to be more like him. He is so much better than I am. You can find his YouTube channel at:

   / @tasosmoschatos  

My videos are not sponsored by anyone. The products and tools I use are products and tools I have purchased with my own money. I include links below to any special tools or products used in this video.

The only special tools I used in this video was the metric Flare Nut Wrench Set:

https://amzn.to/45qRCPv

And the WORKPRO 4-Piece Snap Ring Pliers Set to tighten the control nut of the piston:

https://amzn.to/47RhZ2M

That's all the special tools and products I used in this video.

Here are the main topics for the content I will be covering in this video:

Chapter Links:
00:00 Introduction
01:35 Review of Tools Needed
02:09 Review of Parts Needed
02:47 Renewing Sealing Ring for Control Piston
04:44 Installing The Control Piston
05:29 Calibrating Control Piston Clearance
06:54 Installing The Fuel Distributor
08:13 Loosen The Fuel Pressure Regulator First
11:07 Installing The Fuel Pressure Regulator
12:39 Installing The EHA Valve
14:12 Installing Fuel Injection Lines 8-5
19:50 Installing Cold Start Valve Fuel Line
21:46 Installing Air Distribution Line For Injectors 5-8
22:29 Installing The Crankcase Breather Hose
22:54 Installing Fuel Injection Lines 4-3
24:59 Installing Fuel Injection Lines 1-2
27:15 Installing Air Distribution Line For Injectors 1-4
27:54 Installing The Breather Hose
28:12 Final Overview - What's Next

If you did not measure the piston depth, Bosch says the base recess is .6 millimeters. You can find this information on the cis-jetronic.com website. Here’s a PDF with instructions for rebuilding that provides this information and more: https://cis-jetronic.com/public_doc/0...

Here is a link to the on-line manual that I am somewhat following:

https://www.startekinfo.com/service/d...

I will be doing a YouTube live when I start this car for the very first time since 2008. Make sure you get notified when I publish a new video so you don't miss this special one-time event.