This Mystery Cube In A Cube project was inexpensive, fun, and an easy project to make. In this video I go over the steps required to make this project and also the materials and tools that I used. The only material needed for this project is 1 - 3”x3”x3” block of wood, and most of the work is done with a drill press.


**********
TIME STAMPS:
- Marking the Center 0:32
- Initial hole for marking 0:49
- Setting up the drill press 1:35
- Drill the holes 2:29
- Releasing the inner cube 5:29
- Finished product 6:23


**********
MATERIALS NEEDED:
- 1 pc of 3"x3”x3” block of wood (trimmed down from a 4”x4” post)

TOOLS USED:
- Mastercraft Table Saw (to trim the post down to the 3”x3”x3” cube needed)
- Mastercraft Drill Press
- 2” Forstner Bit
- Mastercraft Mouse Sander
- Ruler or Straight Edge


**********
There are NO sponsors affiliated with this video.


**********
If you enjoyed this video, please hit SUBSCRIBE and LIKE and I will continue to add a lot more videos in the near future.

Thanks for watching this video,

RaCo Woodworking