Published On Feb 13, 2024
Support me on Patreon!: / diyfiberlaser
In this video, I set out to make a multi-stage pneumatic air cylinder and a power drawbar system for my Benchman MX milling machine, in order to use the Tormach Tooling System (TTS™). The assembly ended up costing less than $300 to make. Parts listed below:
Lyndex TTS™ Adapter Collet R8:
https://tormach.com/tts-adapter-colle...
TTS 3/4" Straight Shank ER25 M Collet Chuck Tool Holder:
https://www.ebay.com/itm/225567106688
SDA80 x 15 Pneumatic Air Cylinder:
https://amzn.to/42Dd5nH
O-Ring Kit:
https://amzn.to/49mIk8W
Aluminum Round Tube, 300mm Length 18mm OD:
https://amzn.to/49uf5kG
3/8" PT Male Thread 6mm Pneumatic Connector Quick Fittings:
https://amzn.to/3wcOme1
6mm OD Push to Connect Pneumatic Fittings Kit:
https://amzn.to/3OE1nnc
Pneumatic Tubing 6mm x 4mm:
https://amzn.to/48cDZUI
6061-T6 Aluminum Plate 8x12x1/2:
https://amzn.to/4bCrqFl
1/4"NPT Pneumatic Solenoid Valve 2 Position 5 Way:
https://amzn.to/48iDbOa
McMaster Carr 12” Bolts:
https://www.mcmaster.com/91236A658/
McMaster Carr Belleville Springs:
https://www.mcmaster.com/9712K435/
McMaster Carr 7/16 Draw Bar Bolt:
https://www.mcmaster.com/92800A248/
Channellock 927 8-Inch Snap Ring Pliers:
https://amzn.to/3OBoAGH
My website: https://www.id3ntitycrisis.com
My design portfolio: https://www.id3ntitycrisis.com/portfolio