🔧🔧 DrewFixIt STORE: http://www.drewfixit.com 🔧🔧

In this video I demonstrate how to change the Oil and Oil Filter on a Mazda 3. Specifically I am demonstrating this on a Third Generation Mazda 3 (2013 and onwards), however this really does apply to any Mazda 3. This is not a complex procedure, so you should have no issues!

What you will see is that I step by step show you how to do this procedure safely with minimal tools. In particular I have attempted to film all of the steps involved without avoiding the trickier elements of this task.

Tools Used:

* Push Pin Removal Toolkit: https://amzn.to/4bFjN0E
* Phillips Head Screwdriver (https://amzn.to/48mG9RD)
* Oil Filter Wrench: https://amzn.to/3uBlZFV
* 8mm Hex Bit (https://amzn.to/48gK16L)
* 17mm Socket (https://amzn.to/3I00SQI)
* 3/8 Socket Wrench (https://amzn.to/3HWMCIz)
* Torque Wrench (https://amzn.to/3HXOUH9)
* 3 Ton Low Profile Floor Jack (here is a video on my jack:    • Toolpro 3000kg Low Profile Garage Jac...  )
* Jack Pad: https://amzn.to/3LmVSrt)
* Heavy Duty Jack Stands: https://amzn.to/468Vkhn
* Wheel Chocks: https://amzn.to/3EDGQd8

Consumables Used:

Oil Filter (Mazda PE01-14-302): https://amzn.to/3SX85aj *** I used a RYCO Z926 in this video.
Engine Oil: 0w-20 Fully Synthetic: https://amzn.to/49gbk2m
Drain Plug Gasket (9956-41-40099 or 99564-1400-ST): https://amzn.to/48iGnt6
17MM Drain Plug (LFE5-10-404):

You too can do it yourself and save the cash!!

I trust that you enjoy the video and if you would like to support the channel on an ongoing basis then please do consider joining the channel as a Member. I have deliberately kept the cost of the membership levels low, please check the membership levels out here:

   / drewfixit