3D Prints can be post processed, so that the look used and aged.

This is about patinating metal filament 3D prints, as well as plated 3D prints and painted with metal lacquer.

Here I would like to show you how easy it is to #patinate your #3dprints. There was some experimentation involved in this.

**I have not received any of the products shown free of charge, nor do I have any relationship with the manufacturer.*

TIMESTAMPS:
00:00 Introduction
00:31 Filament & Materials suitable for Patination
01:28 Method 1: Patination from Eggs
02:40 Warning!
02:57 Method 2: Patination from Ammonia Solution Fumes
04:17 Method 3: Patination from Ammonia, Vinegar and Salt Mix
05:17 Special: Commercial Product
06:30 Extro

~~~~~~~~~~~~~~~~~~~
Models I printed for the Test 📢

Surprise Egg #8: https://www.thingiverse.com/thing:333...
3DBenchy: https://www.thingiverse.com/thing:763622
Cthulhu Idol: https://www.thingiverse.com/thing:208...
Goonies Pirate Coin: https://www.thingiverse.com/thing:387...
Indy Head Piece for Staff of Ra 🥇: https://www.thingiverse.com/thing:202589

~~~~~~~~~~~~~~~~~~~

For the metal prints I used:
Copperfill Filament from ColorFabb
Bronze Filament from ColorFabb

The Ration for the Patina Spray is:
#2 Parts of White Vinegar
#1.5 Parts of Ammonia Solution
#0.5 Parts Salt

For the galvanic bath:
a container
copper electrolyte (sour)
one or two copper anodes
banana plug & alligator clips

You may need:
Degreaser
Distilled water
Conductive Copper Spray. Make sure that it can be used with your copper electrolyte.

Have fun. Try it. 🧡


Have a look to my other Videos
######################

DIY Electroplating 3D Prints ... (the shiny way) 🧪
   • How to Electroplate 3D Prints … (the ...  

Metal Plating a Monkey Island Verb Coin
   • Video  

Printing an Evil Dead Necronomicon
   • 3D Printed Necronomicon - DIY Book Co...  

#3dprinting #3dprints #DIY #postprocessing