Published On Sep 2, 2023
If you've tried 3d printing a ball joint, like the ones use in PrintABloks, you may have run into a problem. The joints start out fine, but over time they loosen. Fortunately there's a couple of solutions you can employ, and Cymon and I will tell you all about them.
3D Printing Professor is made possible by YOU!
https://www.3dpprofessor.com/support/
I'm social!
/ discord
https://mastodon.online/@3DPProfessor
/ 3dpprofessor
/ 3dprofessor
Buy the Beginner's Guide to the 3D Printing Galaxy on Amazon: https://amzn.to/2ws7OiT
Shop on Amazon to support the channel: https://bit.ly/3DPPrinters
Follow my other 3D printing adventures at: https://www.3dpprofessor.com
Join the mailing list and never miss anything important: https://bit.ly/3DPPnews
00:00 Why are my joints loose?
05:13 Solution : Bluetak
06:30 Solution 2 : Swap for Tighter
07:38 Solution 3 : Nailpolish
08:38 Solution 4 : Print in PetG
09:23 3D Print to Win