This is my take on installing the Gen 2 Hex EzCan on my new June 2022 R1250GS. There may be other ways!!!!!

Accessories to be added to the circuits at a later date.

Should take you between 30-45 minutes.

I removed the rear seat base plate and grab rail, that takes 5 minutes, but makes install easier.

My BMW has the tyre pressure monitoring system installed and works BUT there is no RDC (tyre pressure control unit) normally found under the rear seat. BMW have now removed the RDC and left a capped plug, labelled RDC.

This is what you use, so, only 1 plug from the hex is used and the other is redundant. This was confirmed to me by tech support from HEX themselves .

Once installed, the Hex unit will flash green, once the bike is switched on this changes to a steady green.

The unit was purchased from Rugged Roads
https://ruggedroads.co.uk
HEX ezCAN II for BMW R1200 / R1250 LC
£155

Further product information etc
https://www.hexezcan.com