In this video, I go over installing Pergo 4 in 1 transitions on concrete with no screws. When trying to install the metal U track they send with the transitions, its not always easy to lineup the whole perfect so that your transition is tight against the granite and tight against the other miters. Rather than fight it, I like to use a urethane glue, hot glue, and C A glue to get the job done. This will ensure that my transition will be tight at the miters and against the tile or hearth with maximum hold. Hope you enjoy the video!

Thank you to all the subscribers and supporters of this channel!

Tools You May Need: (affiliate links below)

Angle Finder
https://www.amazon.com/gp/product/B07...

CA Glue
https://www.amazon.com/gp/product/B01...

Laminate Cutter
https://www.amazon.com/gp/product/B07...

Speed Square
https://www.amazon.com/gp/product/B00...

Nail Puller (cats paw)
https://www.amazon.com/gp/product/B00...

Pry Bar
https://www.amazon.com/gp/product/B00...

Hammer
https://www.amazon.com/gp/product/B07...

Tape Measure
https://www.amazon.com/gp/product/B01...

Tin Snips
https://www.amazon.com/gp/product/B00...

White Putty
https://www.amazon.com/gp/product/B00...

Dark Walnut Putty
https://www.amazon.com/gp/product/B00...

DISCLAIMER: This video and description contains affiliate links, which means that if you click on one of the product links, I will receive a small commission (at no extra cost to you of course). This helps support the channel and allows me to continue to make videos like this. Thank you for your support!