Published On Jul 24, 2022
G'day everyone,
The lathe is in need of some maintenance this week. After machining the new cross slide last year I ran out of material to make the riser block, so I substituted it with a piece of Aluminium. It has almost been a year since then and it is time to replace the Aluminium one with one made from steel.
I am also going to replace the tool post stud for a solid one made from steel to make the tool position more repeatable and make it a bit more rigid.
#machining #lathe #diy
Timestamps
0:00 -Intro
0:46 - Machining the Riser Block From Steel
3:58 - Machining The tool post Stud
7:18 - Counterboring The Tool post
8:13 - Assembly and test
show more