Universal RF amplifier Design - From Schematic to Measurements

Get my free Electronics Product Development Checklist
https://www.hans-rosenberg.com/checklist

Check out my courses
https://www.hans-rosenberg.com/courses

In this video, I'm going to show you a very simple way to design a universal RF amplifier. We'll go over component selection, schematic design, pcb design / layout and measurements. We'll also look at the impact of ferrite beads versus resistors in the biasing circuit and the impact of capacitors on the analog performance.

0:00 introduction
0:14 What amplifiers are we talking about
0:47 The selected amplifiers
1:20 Application diagrams
2:00 Single stage amplifier schematics
3:42 Single stage amplifier layout
5:13 Single stage amplifier measurement options
5:54 Measurement setups
8:01 Single stage amplifier measurement results
10:05 Dual stage amplifier schematics
10:51 Dual stage amplifier layout
11:16 Dual stage amplifier measurement options
11:43 Dual stage amplifier measurement results
12:23 Bias current checks
12:54 Good bye and hope you liked it