This video is a full guide on how to assemble a USBValve. USBValve is a handy gadget that is used to test and verify USB devices and provide immediate feedback on the attached OLED Screen. The github page for the project is https://github.com/cecio/USBvalve?tab... and all credit goes to the original creator. This is also where you can find the firmware to get your device working once you build it. If you need assistance with building a USBValve visit my website https://www.tzirf.com/tech-gadgets/us...

0:01 Intro : What this video is about
1:26 Picture showing what pins to solder on the Raspberry Pi Pico
1:44 Soldering Raspberry Pi Pico to USBValve PCB
5:12 Prepping the OLED Display to be soldered
5:55 Where to solder OLED Display to the PCB
6:30 Soldering OLED Display to PCB
8:03 Bridging GND2 & VCC2 Pads
9:00 Soldering the GND2/VCC2 Pads (under microscope)
10:04 Cleaning flux off back of PCB
10:41 Prepping USB A Port to be soldered to the PCB
11:20 Soldering USB A port to PCB
13:08 Soldering 4 pins to USB Port (under Microscope)
15:20 Outro

For additional resources & guides you can visit my website https://www.tzirf.com. It is a forum based website where I post all the repairs I am working on so that the resources are there for others to do the same repairs. If you are working on a repair and want to share it, or need help with your repair I encourage you to join and make a post.

Music: Bensound.com
License code: EGCHA2Y6AMRYJPRM