finally after some time i was able to get my hands on a thrustmast TMX to do my handbrake mod tutorial video. this covers how to dissemble and wire the wheel to be able to use a handbrake.


WARNING this will void the warranty on any of the thrustmaster products, I DO NOT take any responsibility for anything that can happen to your thrustmaster products, This is at your own risk!

Tools/supplies needed for this complete series:
-Philips screwdriver
-Soldering pen
-Flux core solder
-Flux
-Wire strippers/crimpers
-Small pliers
-2.5 metric Allen wrench
-4 to 6 wire connectors
-1/4" Heat shrink tube, at least 5ft or Electrical tape
-2 pin LED jump plug connector or a 2 pin connector of your choice
-Heat gun/hair dryer, or some other sorce or heat to shrink the heat shrink tubing, if not using shrink tubing don't worry about it.
-10ft of awg 22 or 24 speaker wire i used 22.
-Small momentary button
-Cheap hydraulic hand brake
-The rest will be gone over in the videos.

HANDBRAKE- http://amzn.to/2tmhy0e
SHRINK TUBING- http://amzn.to/2tm3HXV
MOMENTARY BUTTON- http://amzn.to/2tVfd9E
CONNECTOR- http://amzn.to/2tmcwB8
SOLDERING KIT- http://amzn.to/2tVdIbA
WIRE STRIPPERS/CRIPMS- http://amzn.to/2sjYcUT

WIRING SERVICES-
If you would like me to do this for you, contact me at the e-mail below and we can go over the details.
CONTACT E-MAIL- [email protected]