*Previously known as Glitter Baddies Boutique. Now Known as Creatively V.

This tutorial will be my process from start to finish on how I do rhinestones with stainless steel tumblers. All products will be listed below. My process is not the only way, but this is what I found works best for me.


Shop my tumblers: https://www.creativelyv.com/

Join Our Facebook community: https://m.facebook.com/groups/2442007...

rhinestones: https://www.itsprettypersonal.com (Opalina 5mm)
Code: VIENNA10

Tumbler Blanks: https://makerflocrafts.com?sca_ref=2076654.3X6gbdGiGj

Epoxy recommendation: Super Clear Epoxy:
https://amzn.to/44B0kKH - 1 GAL
https://amzn.to/3XU0ASB -2 QT
* if you are just getting started I would recommend getting a smaller set.

Other supplies you'll Need:
Sanding Sponges/ sanding paper: https://amzn.to/46RaTe5

Gloves: https://amzn.to/44yJbkQ

respirator mask: https://amzn.to/3pWGXN9

spray paint (or acrylic paint)

wax pencil (rhinestone Picker): https://amzn.to/3rA4QKU

Liquid fusion (heavy duty adhesive): https://amzn.to/3O0yuAm

Cup Turner: https://amzn.to/3pVsAZs
(This is one I've had in the past- the ones shown in the video are from MHTurners.com)

Heat Gun (optional): https://amzn.to/3XZTz2o (i've had mine over 3 years)

Torch (optional): https://amzn.to/43BgceS
(Torch is not required, but really helps remove air bubbles in resin as your cup is spinning, you can use a heat gun in place of a torch, but again it will not remove air bubbles as well as a torch does)

Tumbler Faves:
https://www.amazon.com/shop/creativel...

https://linktr.ee/creativelyv