Getting going on your CNC can be daunting in the beginning and in this video I go over some of the first steps, getting your first bits and go over an easy project you can do as well.

If you like what I'm doing here and want to support my channel, take a look at my Patreon page!:
  / coffeycustombuilds  

Check my website for products, templates, digital downloads and merch!
https://www.coffeycustombuilds.com

Here's the list of bits I recommend to get started (affiliate links):
1/4" Down Cut End Mill: https://bitsbits.com/product/425-dnc2...
1/4" Compression Spiral: https://bitsbits.com/product/425-cm25...
1/8" Down Cut End Mill: https://bitsbits.com/product/425-dnc1...
1/4" Up Cut Ball Nose: https://bitsbits.com/product/srb4-250...
Spoil board flattening bit: https://bitsbits.com/product/6210-fla...
Round Nose Bit: https://bitsbits.com/product/1404-rou...
90 deg. V bit: https://bitsbits.com/product/1502/ref...

Affiliate Links (These help support my channel):
Totalboat: https://bit.ly/3IEHrOr
Starbond: https://bit.ly/3ITPpUy
MircroJig: https://bit.ly/3XecHbP
Magswitch: https://bit.ly/3H6uhJl
Bits & Bits: https://bitsbits.com/ref/6233/
Rustic Lumber Finish: https://bit.ly/3mZWDxF
Bidwell Wood & Iron: https://bit.ly/40geRJL (Use code COFFEY10)
Jobber: https://bit.ly/3iPzZps
Grabo: https://order.grabo.com/u/Coffey
Coffey Grinds: https://bit.ly/3GKL6rR

#cnc #tools #woodworking
00:00 Introduction
00:26 First steps
01:05 Why a flat spoil board matters
01:37 Flattening bits
02:52 Set up a job in CAM software
07:22 Tooling needed
10:31 Make a valet tray
15:02 Cutting your first project