Did you pour an epoxy project that won't cure and is sticky? That epoxy will most likely never set up so this is how you can make that project usable at the very least!
1. Remove any bugs/debris that have become trapped in the stickiness! We used a chisel to accomplish this as a sander was out of the question.
2. Clean up the edges as much as possible
3. Prep it for an epoxy flood coat - clean, tape dam, mix (DOUBLE POT THE EPOXY), spread, & heat to pop bubbles
4. Let the first flood coat dry - then you can properly sand the table
5. Prep it for the second flood coat & pour
6. Let it set up and dry thoroughly

By coating the uncured epoxy thoroughly, this will make the table usable at the least. Ultimately, we removed (but left a few cool ones) bugs, made the edges nicer, leveled out the top, and coated everything that was sticky with cured epoxy so that it can be touched.

Get your epoxy for your next project at ucwoods.com
.
.
.
www.facebook.com/ucwoods417
instagram.com/uc_woods
Tik Tok: @ucwoods