Please subscribe! http://www.fixit4free.com http://www.cleverproducts.co.uk How to remove the front bumper on the 2007-2012 Mazda 6.

You will need a cross head screwdriver.
8mm socket
10mm socket
Bojo Tip 5 and Tip 9.

Start by removing the grille, the rubber bungs are hidden trim clips that have a small slot on them. You may be able to stick a flat head screwdriver in but I find that removing the rubber from the top and using a Bojo tool to open is easier. Remove the centre 2 trim clips using Bojo Tip 5 and remove the 2 cross head screws. The grille can now be removed.

Underneath the car in the centre you need to detach the front under tray. This has 8 10mm bolts however you only need to remove the front 4 to allow the tray to drop down. Once removed there is a trim clip in the centre to undo and the tray will drop down.

In the wheel arches there is 1 8mm screw to remove and 3 trim clips than can be gently undone with a cross head screwdriver and pulled out.

Underneath the front corners of the bumper there are 4 8mm screws to remove to detach the corner under trays.

The bumper will now be loose but you will need to take care when detaching the sides as on the drivers side there is the pipe for the headlight washers to remove and on the passenger side you need to remove the wiring for the fog lights.

With the sides loose and the components disconnected the bumper will only be held on by a small tab next to each headlight. This can be undone by inserting a slim Bojo tool such as Tip 9 or Tip 1.

Thanks for watching.

www.fixit4free.com