This video will go over my method and settings for etching onto clear glass sheets using the Atomstack A5 M50 Pro diode laser (5.5-watt) and the lightburn software.

I'm using thick black posterboard/card stock on top of a standard honeycomb bed under a 1.6mm glass sheet. I think the results turned out really nicely without the need for paint or complex prep and clean-up. This is pretty much the identical process to my video on etching clear acrylic, just with significantly different power and speed settings.

00:00 Start (Material tester glass sheet and sample etched image)
02:54 Lightburn - Material Test project explanation
06:22 Lightburn - Project setup
07:38 Layer Configuration (Speed, Max Power, Image Mode)
09:04 Laser Setup (Honeycomb, poster board, glass material, 2mm spacer)
10:09 Etching Process
11:50 Glass Sheet immediately after etching
12:40 Finished Product after cleaning

Glass Sheets - https://www.amazon.com/dp/B08R8Q5PBF
Posterboard used for backing - https://www.michaels.com/product/22-x...