Published On Feb 11, 2023
This video is a follow up to my previous one on DIY Vacuum Clamps. In this video I have tried to capture a different approach when it comes to making these the second time around. I have demonstrated another method purely done in my workshop without any CNC machine to achieve the much needed groove in these suction pads to accommodate the round rubber seals used. These suction clamps/pads that I have made work well with the use of a small suction pump bought online together with a foot pedal which diverts the air when you need to release your material from the suction pad. They are made from lightweight PVC board (dense plastic board) which is easy to work with.
Affiliate Links:
PVC Foam Board (1/2" thick - 8"x10"):
https://amzn.to/490Ix2b
PVC Foam Board (1" thick - 12"x12"):
https://amzn.to/491h2pc
https://trademaster.com.au/product/wh...
https://www.nover.com.au/prolight-pre...
Round Rubber Seal:
https://amzn.to/3wZqPdE
Router Cutter to Suit 6mm Seal:
https://amzn.to/3ZHThNT
Pneumatic Fitting Push-In 1/4” x 8mm:
https://amzn.to/40qSBxj
Pneumatic Tube 8mm x 5m:
https://amzn.to/45GOyy3
Vacuum Pump (NOTE: NOT THE SAME PUMP AS I PURCHASED BUT SIMILAR! - check the pump has your countries power-point plug):
https://amzn.to/495AeSy
Pneumatic Foot Pedal:
https://amzn.to/3HCUyxL
Round Over Edging Router Bit Set:
https://amzn.to/3FmWf2f
Inline Filter (to help catch any dust going into machine):
https://amzn.to/3reWhVu
Microjig Matchfit Clamp Set:
https://amzn.to/3jySpLD
Makita 18V Trimmer (I am NOT Sponsored by Makita):
https://amzn.to/3KXImuZ
Video Links:
DIY Vacuum Video (1st Video/Version):
• DIY Vacuum Clamp | Vacuum Workbench C...
DIY Benchtop Router Table:
• DIY Benchtop Router Table Build | Min...
Adjustable Router Jig:
• Adjustable Router Jig for Square Hole...