Published On Nov 5, 2022
Follow these steps so your salt cell will get a correct salt level reading and restore lights/error codes!
Join this channel
/ @poolcareworld
First measure out water in a pitcher or jug with at least 70-75 % water to 20-25% muratic acid, always leave plenty of room for muriatic acid to be added and never add water to acid! Always make sure power is off or disconnected before cleaning salt cell. Safety glasses and gloves recommended.
If you're you are having issues after cleaning your salt cell and making sure both salt cell and pump timers are in sync, insure the salt reading in the pool is 3000-4000ppm, THEN if possible remove cartridge filter and run without it for 15-30 minutes to see if the lights go green. if so replace filter with a high quality name brand filter: unicel, pleatco or the manufacture brand ONLY!
Please support us by using our Amazon Affiliate links on products used in this video!
Salt Cell & Power Center we recommend
https://amzn.to/3F6PeSq
https://amzn.to/46KM1nH
Taylor Salt Test Drop Kit we recommend
https://amzn.to/3ZL6vKq
Electronic Salt tester we recommend
https://amzn.to/48NaudC
We use a Hayward Turbo cell salt cell tower for cleaning.
https://amzn.to/3tgVlkw
Pentair Salt Cell/ Union Orings
https://amzn.to/46lVXE2
Lube used for lubricating Orings
https://amzn.to/48VXO4q
High Quality Gallon measuring cup
https://amzn.to/3F6Xke3
Thanks for watching please comment any questions and Subscribe!