Published On May 7, 2017
Ihr wolltet wissen wie meine Einstellungen bei Cura sind für meinen Anet A8. Ich hoffe ich konnte euch hiermit helfen.
Cura: https://ultimaker.com/en/products/cur...
Anet A8: http://amzn.to/2o7rJyS
PLA Dunkelblau: http://amzn.to/2qQcpZm
PLA-Hellblau : http://amzn.to/2qP8P2v
Skalpell: http://amzn.to/2qFtIja
Bluetape: http://amzn.to/2pT27dF
Diamantfeilen: http://amzn.to/2p9orQX
▽ Follow Kiss The Pro
Intagram: / kissthepro
Twitter: / kissthepro
Mein Equipment!
Sony A68: http://amzn.to/2nKECzp
DJI Mavic Pro: http://amzn.to/2nrZOLh
GoPro Hero 5: http://amzn.to/2nKCNCH
GoPro Arm: http://amzn.to/2o7hdZ3
Rode Mikrofon: http://amzn.to/2oJ4dJT
SD Karte: http://amzn.to/2nKErnH
Anet A8: http://amzn.to/2o7rJyS
_________________________________________________________________
G-Codes starten:
G21 ;metric values
G90 ;absolute positioning
M82 ;set extruder to absolute mode
M107 ;start with the fan off
G28 X0 Y0 ;move X/Y to min endstops
G28 Z0 ;move Z to min endstops
G1 Z15.0 F9000 ;move the platform down 15mm
G92 E0 ;zero the extruded length
G1 F200 E3 ;extrude 3mm of feed stock
G92 E0 ;zero the extruded length again
G1 F9000
M117 Printing...
G-Codes beenden:
M104 S0 ;extruder heater off
M140 S0 ;heated bed heater off (if you have it)
G91 ;relative positioning
G1 E-1 F300 ;retract the filament a bit before lifting the nozzle, to release some of the pressure
G1 Z+0.5 E-5 X-20 Y-20 F9000 ;move Z up a bit and retract filament even more
G28 X0 Y0 ;move X/Y to min endstops, so the head is out of the way
M84 ;steppers off
G90 ;absolute positioning